Picoma SpeedCouple: Turn the Coupling, Not the Elbow
Installing a rigid elbow where there is no room to swing it is one of the slower jobs on a conduit run. The usual answer is a three-piece coupling and a lot of careful turning. Picoma built the SpeedCouple elbow to take that step out.
The coupling comes pre-installed
The SpeedCouple elbow arrives with its coupling already on. Instead of rotating the elbow into place, you turn the coupling, and the lead-in threads do the work. The elbow stays where you set it.
Sizes and radii
SpeedCouple is available in trade sizes 2 through 6, on both standard-radius and special-radius rigid elbows.
Time and material
Picoma says the SpeedCouple elbow takes about half the time to install and can cut material cost by up to 50 percent compared with using three-piece couplings.
Domestic pipe
The elbow is made from 100 percent domestic pipe.
Talk to your Electra Sales rep
For Picoma SpeedCouple elbows, standard- and special-radius elbows, nipples and couplings, contact your Electra Sales representative.
Comments